![]() ![]() In any event, in anticipation of getting mine, would you mind providing the inner dimensions of the battery compartment. Hope they've come up with a quick solution to replace it. I just got shipping confirmation on mine and since I more than likely have to open it anyway to adjust throttle friction, I'll be on the look out for that. The telemetry port works perfectly with a 915 mhz radio.īob, maybe you could enable the debug output of the teensy to see if your board is actually sending all mavlink messages?Īnother wild guess, did you change uart for the mavlink port when switching over to the new board? perhaps the parameters you copied over did not set the correct SRn_ message rates for this port? The voice announcements like flight mode and GPS lock work. I an not getting the "No Telemetry Data" block on the screen. I copied over the parameters and the replacement works like a champ except the Yappu screen is populated with 0s. I replaced it with another APM 2.6, but with vertical pins and possibly a later version. ![]() Unfortunately the gyro or accelerator went bad. The copter has an endurance of around 25 minutes so I'll be able to have fun with missions, and the script was working perfectly except for current and total amperage used. I used an APM 2.6, which I successfully run Yaapu scripts on an F450. I was rifling through the old parts box and I decided to put together an F330 for some fun flying. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |